Division 9 Ebook Page 43 Omni Plane Diffuser Panel

Omni Plane Diffuser Panel 1. Construction: Composite core with two layers of dimensionally stable rigid fiberglass separated by a barrier septum. 2. Core Fiberglass Density: 6 - 7 pcf. 3. Recycled Content: For fiberglass, 52 percent pre-consumer and 5 percent post-consumer recycled content. 4. Core Thickness: 1 inch. 5. Core Thickness: 2 inches. 6. Size for Ceiling Applications: 36 by 60 inches and custom. 7. Size for Wall Applications: 48 inches wide by 120 inches high and custom. 8. Edge Profile: Square. 9. Finish: Manufacturer, pattern and color as selected: applied directly over face and edges of panel and returned to back of panel to provide full finished edge; corners fully tailored. 10. Mounting Type for Ceiling Applications: Z-Bar to Z-Bar. 11. Mounting Type for Ceiling Applications: Lay-in. 12. Mounting Type for Walls: Panel clip. 13. Mounting Type for Walls: Impaling / adhesive. 14. Flammability (ASTM E 84): Panel components shall have a Class "A" rating per ASTM E 84. 15. Acoustical Performance: Values below are for panels mounted in accordance with ASTM C 423 (Type D5 Mounting) and vary by panel thickness and finish. a. Noise Reduction Coefficient (NRC) for 1 inch thickness: 0.65. b. Noise Reduction Coefficient (NRC) for 2 inch thickness: 0.90. PART 3 - EXECUTION 3.1 INSTALLATION A. Verify wet work such as plastering and concrete is complete and dry. Verify building is enclosed and under standard occupancy conditions (60 - 85 degrees F and not more than 70 percent relative humidity) prior to start of installation. Commencement of installation constitutes Installer's acceptance of surfaces and conditions. B. Install products in accordance with manufacturer's written instructions and in proper relationship with adjacent construction, including the following: 1. For adhesive installation to substrate, provide temporary support to prevent panel slippage. Note: Impaling clips are designed to help hold panels in place until adhesive dries.. C. Touch-up, repair or replace damaged units until satisfactory results are obtained. END OF SECTION 2014 Owens Corning. All Rights Reserved.

Previous Page
Next Page