Division 9 Ebook Page 37 Reflective Wall Panels

Reflective Wall Panels 1. Construction: Dimensionally stable rigid fiberglass with 6 - 7 pcf density covered with 1/16 inch copolymer, total thickness 1-1/16 inch. 2. Reflectors (Optional): Dimensionally stable rigid fiberglass with 6 - 7 pcf density covered with 1/16 inch copolymer, total thickness 1-9/16 inch. 3. Reflectors (Optional): Dimensionally stable rigid fiberglass with 6 - 7 pcf density covered with 1/16 inch copolymer, total thickness 2-1/16 inch. 4. Reflector Size: 53 inches wide by 120 inches maximum and custom. 5. Recycled Content: For fiberglass, 52 percent pre-consumer and 5 percent post-consumer recycled content. 6. Edge Profile: Square. 7. Edge Profile: Half-bevel. 8. Edge Profile: Miter. 9. Corner Detail: Square. 10. Corner Detail: Radius. 11. Finish: Manufacturer, pattern and color as selected; or gel-coat only; gel-coat applied directly over face and edges of panel and returned to back of panel to provide full finished edge; corners are fully tailored. 12. Reflector Mounting Type: Adhesive / resin. 13. Reflector Mounting Type: Adhesive, no resin. 14. Reflector Mounting Type: Impaling / adhesive. 15. Reflector Mounting Type: Velcro. 16. Reflector Mounting Type: Panel clip to double wall clip. 17. Reflector Mounting Type: Z-bar to Z-bar. 18. Reflector Mounting Type: Panel clip and Velcro. 19. Flammability (ASTM E 84): Panel components shall have a Class "A" rating per ASTM E 84. 20. Acoustical Performance: Values below are for panels mounted in accordance with ASTM C 423 (Type D5 Mounting) and vary by panel thickness and finish. a. Noise Reduction Coefficient (NRC) for 1-1/16 inch Thick Fiberglass-Based Reflectors: 0.20. PART 3 - EXECUTION 3.1 INSTALLATION A. Verify wet work such as plastering and concrete is complete and dry. Verify building is enclosed and under standard occupancy conditions (60 - 85 degrees F and not more than 70 percent relative humidity) prior to start of installation. Commencement of installation constitutes Installer's acceptance of surfaces and conditions. B. Install products in accordance with manufacturer's written instructions and in proper relationship with adjacent construction, including the following: 1. For adhesive installation to substrate, provide temporary support to prevent panel slippage. Note: Impaling clips are designed to help hold panels in place until adhesive dries. C. Touch-up, repair or replace damaged units until satisfactory results are obtained. END OF SECTION 2014 Owens Corning. All Rights Reserved.

Previous Page
Next Page