Division 9 Ebook Page 27 RespondŽ Reflector Ceiling Clouds, Flat

Respond Reflector Ceiling Clouds, Flat 2. Recycled Content: For fiberglass, 52 percent pre-consumer and 5 percent post-consumer recycled content. 3. Medium Density Overlay (MDO) Thickness: 1/2 inch. 4. Medium Density Overlay (MDO) Thickness: 3/4 inch. 5. Backing Thickness: 1 inch. 6. Backing Thickness: 1-1/2 inches. 7. Backing Thickness: 2 inches. 8. Backing Thickness: Custom. 9. Width: 24-48 inches and custom. 10. Length: 24-120 inches and custom. 11. Corners: Square. 12. Corners: Radius. 13. Edge Profile: Square. 14. Edge Profile: 1/2 inch bevel. 15. Finish: Manufacturer, pattern and color as selected; gel-coat applied directly over face and edges of panel and returned to back of panel to provide full finished edge; corners are fully tailored. 16. Mounting Type for Flat Reflectors: Standard, cloud angle. PART 3 - EXECUTION 3.1 INSTALLATION A. Verify wet work such as plastering and concrete is complete and dry. Verify building is enclosed and under standard occupancy conditions (60 - 85 degrees F and not more than 70 percent relative humidity) prior to start of installation. Commencement of installation constitutes Installer's acceptance of surfaces and conditions. B. Install products in accordance with manufacturer's written instructions and in proper relationship with adjacent construction, including the following: 1. For adhesive installation to substrate, provide temporary support to prevent panel slippage. Note: Impaling clips are designed to help hold panels in place until adhesive dries. C. Touch-up, repair or replace damaged units until satisfactory results are obtained. END OF SECTION 2014 Owens Corning. All Rights Reserved.

Previous Page
Next Page