Division 9 Ebook Page 134 SelectSound’ Black Acoustic Blanket Data/Submittal Sheet

Product Data Sheet CDC CORPORATION 800 Gustafson Road Ladysmith, Wisconsin 54848 1-800-932-2383 www.conweddesignscape.com 1-800-359-3312 www.walltechnology.com Pub. No. 10018366. Printed in U.S.A. February 2013. 2013 Owens Corning. All Rights Reserved. LEED is a registered trademark of U.S. Green Building Council. SELECTSOUND BLACK ACOUSTIC BLANKET INSTALLATION PROCEDURE SelectSound Black acoustic blanket can be installed on drywall, concrete block or precast concrete using impaling pins or appropriate adhesives. When installing insulation with adhesive, follow adhesive manufacturer's recommendations for surface preparation and pattern. When using impaling pins, follow the pin manufacturer's recommendations for surface preparation, location and amount of pins. Pin length should be selected to ensure tight fit. Where subject to physical contact, protect pin tips. Keep product dry during shipping, storage and installation. Owens Corning reserves the right to change this product as needed. Caution: May cause temporary irritation to skin, eyes and respiratory tract. Avoid contact with eyes and skin. Wear long-sleeved, loose-fitting clothing, gloves and eye protection when handling and applying material. Wash with soap and warm water after handling. Wash work cloths separately and wipe out washer. Acoustical Performance Tested Values - SelectSound Black Acoustic Blanket Sound Absorption Coefficients (ASTM C 423, Type "A" Mounting) Product Density Thickness Octave Band Frequencies, Hz. Thermal Resistance 1 R-Value (hrft 2 F)/Btu pcf kg/m 3 in mm 125 250 500 1000 2000 4000 NRC* SelectSound Black 150B 1.5 24 1.0 25 0.08 .025 0.49 0.72 0.86 0.91 0.60 3.8 Acoustic Blanket 1.5 24 1.5 38 0.16 0.36 0.61 0.83 0.90 0.92 0.70 5.8 1.5 24 2.0 51 0.20 0.53 0.79 0.94 0.95 0.97 0.80 7.7 2.0 32 2.0 51 0.20 0.55 0.87 1.00 0.95 0.95 0.85 8.0 1 ASTM C518 These data were collected using a limited sample size and are not absolute values. Reasonable tolerances must therefore be applied. All tests were conducted in accordance with ASTM C 423, Type A mounting (material placed against a solid backing such as a block wall). Owens Corning Granville Science & Technology Acoustics Lab is National Voluntary Laboratory Accreditation Program (NVLAP) approved. Conceptual Details For CSI type sample specification, please contact your local Owens Corning representative.

Previous Page
Next Page