Division 7 Ebook Page 412 ELAMINATOR Insulation System, 07 21 16

OptiLiner Banded Liner System, Thermal, Metal Building 1.1.1.3 DESIGN REQUIREMENTS A. Insulation R-Value of ________ for installed roof system. B. Insulation R-Value of ________ for installed wall system. C. The installed roof and wall systems shall provide a continuous vapor barrier. 1.1.1.4 SUBMITTALS A. Product Data: Provide manufacturer's data for each of the following including: 1. Roof installation instructions 2. Wall installation instructions 3. Product data sheet 4. Design considerations guide 5. Recycle content certification for fiberglass insulation products - minimum 50% recycled content for all fiberglass insulation materials. B. Shop Drawings: Provide shop drawings that indicate the following: 1. Liner fabric layout 2. Insulation Layout and cut list 3. Customer and project information 1.1.1.5 QUALITY ASSURANCE A. Installer Qualifications: Companies shall be familiar with the installation practices associated with banded liner systems. 1.1.1.6 DELIVERY, STORAGE, AND HANDLING A. Store products indoors or in a dry, covered area. B. Do not open products until ready to use. C. Protect products from potential construction site damage. D. Use care when opening products as pallets may shift during shipment. E. Banding has sharp edges. Wear cut proof gloves when handling. F. Wear safety glasses when unpacking materials. 1.1.1.7 PROJECT CONDITIONS A. For best results, do not install this system outside of the temperature, humidity, ventilation and environmental limits recommended by the manufacturer. Products should be kept covered and dry at temperatures less than 100F prior to installation. PRE-ENGINEERED BUILDING BLANKET INSULATION 07 21 16 - 2

Previous Page
Next Page