Division 7 Ebook Page 324 ELAMINATOR® Insulation System Product Data Sheet

Product Data Sheet ELAMINATOR Insulation System Two-Layer unfaced Owens Corning EcoTouch Insulation for MBI Plus or EcoTouch Insulation for Certified R Metal Building between and parallel to the purlins using the 300 Series machines which first install the facing parallel to the purlins. Then the unfaced EcoTouch Insulation for MBI Plus or EcoTouch Insulation for Certified R Metal Building is installed as a second layer over the first unfaced insulation layer and purlins, parallel to the roof sheets. (2) Single-Layer unfaced Owens Corning EcoTouch Insulation for MBI Plus or EcoTouch Insulation for Certified R Metal Building is installed over the purlins, parallel with the roof sheets, using the 100 or 300 Series machines to install the facing parallel to the purlins. The patented ELAMINATOR Insulation System is available for installation of Owens Corning EcoTouch Insulation for Metal Building via a nationwide network of licensees. PureFiber Technology Advantages Verified formaldehyde-free 1 and soft to the touch. Certified by SCS Global Services to contain a minimum of 65% recycled glass content, 18% pre-consumer and 47% post-consumer. 1 Applies to the insulation component only. Certified to meet indoor air quality standards under the stringent GREENGUARD Indoor Air Quality Certification Program, and the GREENGUARD Gold Certification. Thickness recovery provides outstanding thermal and acoustical performance. Uses The Owens Corning ELAMINATOR Insulation System is used to insulate metal building roof assemblies (both standing seam and screw-down type) with fiberglass metal building insulations. The system provides excellent interior appearance; the faced surface of the insulation is uniform in appearance without noticeable exposed seams. No unsightly suspension clips, wires, or bands are required. The system places the insulation over and/or between the purlins: facing tabs are overlapped across the purlins. This contributes to good condensation control. With less compression at the purlins, thermal performance is enhanced. Insulation installed with the ELAMINATOR system can provide a range of thermal performance. In-place U-values meet or exceed recognized energy conservation standards. ELAMINATOR Insulation System uses the Certified ELAMINATOR Operator Program (CEOP) to provide qualified machine operators to install the insulation system for the 300 Series machines. Owens Corning requires each franchisee to assure that a qualified operator is enrolled in the program and on every ELAMINATOR project. Vapor Control Considerations Licensees offer a selection of vapor retarder facings applied and ready for installation. Facings with a maximum permeance rating of 0.1 perm are recommended for optimum moisture condensation control. Detailed performance and physical property data concerning available facings is available from facing manufacturer. Insulation Specifications The ELAMINATOR system offers a choice of two installation methods (see below). Selection of the most applicable method is at the discretion of the licensee depending on installed R-value, job site conditions, and other project specifics. In both cases, installation shall be in strict accordance with Owens Corning's published ELAMINATOR installation instructions, as well as with applicable provisions of the Occupational Safety and Health Act, and with state and/or local safety and health codes.

Previous Page
Next Page