Division 22 23 Ebook Page 32 Pipe and Mechanical Insulation Brochure

5 SSL II with ASJ Max and No Wrap Fiberglas Pipe Insulation SSL II with ASJ Max installation instructions 1. Ambient application temperatures are from 25F (-4C) to 110F (43C). 2. To open the hinged insulation section, pull the lap with the release strip from the jacket. 3. Open the hinged sections and place the insulation over the pipe, taking care not to get dirt, dust or moisture on the overlap area. While preparing to close the insulation, take care not to allow the adhesive on the jacket to contact anything until the insulation is properly lined up and closed over the pipe. 4. Pull the release strip from the jacket lap. Start by pulling the lap down at the middle until the adhesive touches the adhesive strip on the jacket. Press together. Rub firmly with nylon sealing tool or squeegee from the middle of the section towards the end until the lap is securely adhered to the jacket. 5. Apply the matching butt strip centered over the adjoining pipe sections, and rub with firm pressure to complete the positive closure. 6. If the operating temperature of the system is above 100F (37C), it is recommend that if the pipe insulation terminates with an exposed end, apply mastic over the exposed end, per the mastic manufacturer's instructions. Physical property data Property Value Test Method Density (size dependent) 3.5 to 5.5 pcf ASTM C302 Operating Temperature Range 2 0 to 1,000F 3 (-18C to 538C) ASTM C411 Jacket Temperature Limitation -20F to 150F (-29C to 66C) ASTM C1136 Jacket Permeance 0.02 perm ASTM E96, Proc. A Minimum Burst Strength 100 psi ASTM D774/D774M Fungi Resistance Meets requirements ASTM C1338 Composite Surface Burning Characteristics 4 Flame Spread: 25 Smoke Developed: 50 UL 723, ASTM E84 or CAN/ULC-S102 2. Limited to single-layer applications above 650F (343C), but not greater than 6" (152mm) thickness. 3. With heat-up schedule. 4. The surface burning characteristics of these products have been determined in accordance with UL 723, ASTM E84 or CAN/ULC-S102. These standards should be used to measure and describe the properties of materials, products or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. Values are reported to the nearest 5 rating. 7. If the operating temperature of the system is below 100F (37C), the pipe insulation terminated exposed end shall be sealed with a vapor barrier mastic applied over the exposed end per the mastic manufacturer's instructions. 8. Apply systems identification labels by pressure- sensitive labels, or by stencil with spray paint. No Wrap installation instructions 1. Open the hinged sections and place over the pipe, carefully aligned and secured by wires or bands. 2. Jacket and vapor seal as required by the application. Additional installation instructions for both 1. Outdoor applications must be protected from weather. 2. If painting is required, use only water based latex paint. Heat-up schedule Pipe insulation may be installed while the system is in operation at temperatures up to 1,000F (538C) at a maximum thickness of 6". For insulation thicknesses greater than 6" (152 mm), the temperature must be increased from 500F (260C) to maximum temperature at a rate not exceeding 100F (56C) per hour. SPECIFICATIONS

Previous Page
Next Page